Chicken Coop - Final Improvements

Way back in January I first posted about the improvements we began on the chicken coop that came with the house. That weekend we cleared the run of blackberry brambles, made some small improvements to the access panel to the coop, and painted a single coat.

Now, nearly 6 months later, we've completed the rest of the improvements we planned to make and finally have chickens. Here are the rest of the coop updates we made before bringing them home:

Nick cut a new door out of plywood, which was much more sturdy that the original. This new door also includes new hinges, a bolt that secures it shut at night, and a metal hook and screw eye to hold the door open during the daytime. When I went over the entire coop with a second coat of new paint, I also painted the new door:

New chicken feeder and fount

Nick did the same for the access door to the nesting box at the back of the coop. It didn't need to be a thicker wood so we re-used the existing door, but we did add hinges. Before it was just screwed in and you pushed it aside to gain access, with no way to lock it. Like the coop door above, there's a new bolt mechanism to keep this side more secure as well.

I painted this as well. You can see how well it blends in below. 

Now at quick look at the inside:

The inside was pretty dirty, with chicken droppings and old shavings on the floor and nesting box. I swept out all of the shavings and removed the existing cloth ceiling from the top of the nesting box, replacing it with plywood. After the floor was clear, I pulled out the linoleum lining the coop and hosed it down outside. Once dry and placed back in the coop, I put a layer of fresh shavings down.

While I worked on cleaning and painting, Nick focused on outer security. There were some areas that weren't as secure as we'd like, including the door to the run. The door was surprisingly wobbly at the top and bottom and had only one bolt closure in the middle. To strengthen the door, Nick reenforced it by screwing lengths of wood around the entire perimeter. No more wobbly door. He also added a second bolt closure and changed the location of the original, so now there's one down lower and one near the top.

One all the door reinforcements were added, I painted it and the frame of the roof. We also added a door handle. In addition to the door, we did some spot securing of the wire around the run. This was an incredibly well made run and coop. The wire edging was dug down into the ground at least 6-8 inches. The chickens have dug down about that far in a couple areas and the wire continues even deeper.

I also cleaned the run and coop roofs by hosing them down, removing all the leaves and gunk build up with a power wash. That was around the time I added the new and extended gutter and added rain barrel.

Ready for chickens

And the before shot: